Target stopped receiving commands on remote PC last week

[HotkeyNet]

When you press a hotkey, what messages appear on the local copy of HotkeyNet? ("Local" means the PC on which you pressed the hotkey with your finger.)

[vrelies]

in pressed hotkey window... 22:40:25: <Hotkey 5>


under actions this pc (local pc)
22:46:10: <SendWinSF DAOC1> completed: Window found. Target set to 0x90684 "DAOC1"
22:46:10: <key 5> completed


remote pc... nadda after validated stuff.

[vrelies]

but it also says this on local pc....

Sending to 192.1xxxx (the remote pc)
22:46:37: Cannot send to 192.xxxx: either the IP address is wrong or the two copies of HotkeyNet are not connected.

[vrelies]

k i found a problem kinda.... when i hit conneced pcs... details tab, it shows me the IP for the remote pc.... but when i connect on teh local pc it shows connected to a different ip...


And i swapped to build

[HotkeyNet]

but it also says this on local pc....

Sending to 192.1xxxx (the remote pc)
22:46:37: Cannot send to 192.xxxx: either the IP address is wrong or the two copies of HotkeyNet are not connected.

There's your problem.

If you had simply looked for a red message at the beginning, you could have solved the problem almost instantly.

Thread locked. See Rule 1.